Generac 0K63030SRV Ignition Coil Pack Replacement Kit For Air Cooled Generators

Generac 0K63030SRV Ignition Coil Pack Replacement Kit.  Typically found on the Generac 990/992/999CC Air Cooled engines.  This kit comes with 2 ignition coils along with the grounding wire that connects them together and to the bulkhead connector on the engine for the 18 wire and hardware.  This is the recommended kit for ignition coil replacement since it comes with everything you will need for parts and an instruction sheet. 

Replaces 0D4686, 0C3052, 0G3224ASRV, 0G3224A, 0G3224BSRV, 0G3224B, 0G3224TA, & 0G3224TB. Includes 0F1177 Ground Wire.

Note that on some models, the included 18 wire will need to have the single push-on connector cut off and a new slightly smaller connector crimped on.  This is because older models used a smaller 3/16″ press-on connector instead of the 1/4″ connector that’s used currently and on newer models.  This connector will need to be sourced from your local hardware store and is not included.

Also note that on certain model engines, there may be a small amount of filing needed to clear the little brass colored rivet to the engine block.  This takes only a few seconds but is required for proper fitment of the new style coils.  The included instruction sheet explains how to perform this.

Generac replacement parts will also usually fit the following Generac branded generators: Honeywell, Guardian, Siemens, Carrier, Watchdog, Centurion, & Bryant.

If you need Generac generator troubleshooting support, please visit our interactive forum